Notes On Ce Identification - MICRO-EPSILON thermoMETER CT Instruction Manual

Hide thumbs Also See for thermoMETER CT:
Table of Contents

Advertisement

Safety
Do not kink the sensor cable and bend the sensor cable in tight radius. The minimum bending radius is
14 mm (static). A dynamic movement is not allowed.
> Damage to the sensor cable, failure of the measuring device
No solvent-based cleaning agents may have an effect on the sensor (neither for the optics nor the housing)
> Damage to or destruction of the sensor
1.3
The following applies to the thermoMETER CT:
- EU directive 2004/108/EC
- EU directive 2011/65/EU, "RoHS" category 9
Products which carry the CE mark satisfy the requirements of the quoted EU directives and the European
standards (EN) listed therein. The EC declaration of conformity is kept available according to EC regulation,
article 10 by the authorities responsible at
MICRO-EPSILON MESSTECHNIK
GmbH & Co. KG
Königbacher Straße 15
94496 Ortenburg / Germany
The system is designed for use in industry and laboratory and satisfies the requirements of the standards
- EN 61326-1: 2006
- EN 61326-2-3: 2006
The system satisfies the requirements if they comply with the regulations described in the instruction manual
for installation and operation.
thermoMETER CT

Notes on CE Identification

Page 8

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the thermoMETER CT and is the answer not in the manual?

This manual is also suitable for:

CtfCthCtm-1Ctm-3Ctm-2Ctp

Table of Contents