Step 4: Charge The Batteries - Siemens optipoint 200 User Manual

Gigaset 200, GBR, A31008-G200-B101-1-7619
Step 3: Place the handset on
the base unit
In order to make calls, you need to register your hand-
set with the base unit (to make it known to it). The fol-
lowing text appears on the display: "SEARCH BASE".
Put the handset on the base unit with the display
visible. The following text appears on the display:
"REGISTER HS".
It takes around a minute for the handset to be
registered with the base unit. The idle display (battery
symbol) appears instead of the display "REGISTER
HS".

Step 4: Charge the batteries

Leave the handset on the base unit for around five
hours in order to charge the batteries. A charging
indicator on the handset shows that the batteries are
being charged:
H
Batteries empty
(symbol flashes)
.
Batteries
2
Your phone is now ready for operation; you can start
calling.
Note on the battery
8
After the batteries are charged for the first
time, you can put the handset back on the
base unit again after each call. Charging is
controlled electronically. This ensures that
the batteries are charged optimally and
economically.
The batteries become warm during charg-
ing; this is normal and not dangerous.
The charging status of the batteries is only
displayed correctly after an uninterrupted
charging/discharging process. You should
therefore avoid opening the battery
compartment unnecessarily.
8
charged
/
3
VORBEREI.FM

G
Batteries 1
/
charged
E
Batteries full
28.09.01
C
5 h
3