JVC KD-DB902BT Instruction Manual page 28

AUDIO SETTINGS
[SOUND EFFECT]
[SPACE ENHANCE] (Not applicable for FM/AM source and DAB source.)
[SMALL]/[MEDIUM]/[LARGE]: Virtually enhances the sound
space. ; [OFF]: Cancels.
[SND RESPONSE] [LEVEL1]/[LEVEL2]/[LEVEL3]: Virtually makes the sound
more realistic. ; [OFF]: Cancels.
[SOUND LIFT] [LOW]/[MIDDLE]/[HIGH]: Virtually adjusts the sound position
heard from the speakers. ; [OFF]: Cancels.
[VOL LINK EQ] [ON]: Boosts the frequency to reduce the noise heard from
outside the car or running noise of the tyres. ; [OFF]: Cancels.
[K2 TECHNOLOGY] (Not applicable for FM/AM source, DAB source and AUX
source.)
[ON]: Improves the sound quality of compressed music. ;
[OFF]: Cancels.
*1 Displayed only when [SUBWOOFER SET] is set to [ON]. (Page 21)
*2 For 2-way crossover: Displayed only when [SPK/PRE OUT] is set to [SUB.W/
SUB.W].
*3 This adjustment will not affect the subwoofer output.
22
ENGLISH
Speaker output settings
[SPK/PRE OUT]
(Applicable only if [X ' OVER TYPE ] is set to [2-WAY]) (page 21)
Select the output setting for the speakers [SPK/PRE OUT], based on the speaker
connection method.
Connection via lineout terminals
For connections through an external amplifier. (Page 35)
Audio signal through lineout terminal
Setting on
[SPK/PRE OUT]
FRONT
[REAR/REAR] (default) Front speakers output
[SUB.W/SUB.W] Front speakers output
Connection via speaker leads
You can also connect the speakers without using an external amplifier but still being
able to enjoy the subwoofer output with these settings. (Page 34)
Setting on
[SPK/PRE OUT]
[REAR/REAR] Rear speakers output
[SUB.W/SUB.W] Subwoofer output
If [SUB.W/SUB.W] is selected:
– [120HZ] is selected in [SUBWOOFER LPF] and [THROUGH] is not available. (Page 24)
– [POSITION R02] is selected in [FADER] and selectable range is [POSITION R15] to
[POSITION 00]. (Page 21)
REAR
Rear speakers output Subwoofer output
L (left): Subwoofer output Subwoofer output
R (right): (Mute)
Audio signal through rear speaker lead
L (left) R (right)
Rear speakers output
(Mute)
SW