JVC KD-DB902BT Instruction Manual page 23

BLUETOOTH®
Make a call from memory
1
Press to enter Bluetooth mode.
2
Press one of the number buttons (1 to 6).
3
Press the volume knob to call.
"NO PRESET" appears if there is no contact stored.
Bluetooth mode settings
1 Press and hold .
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
4
Press to exit.
To return to the previous setting item, press
[BT MODE]
[PHONE SELECT]* Selects the phone or audio device to connect or disconnect.
" " appears in front of the device name when connected.
[AUDIO SELECT]*
" " appears in front of the current playback audio device.
[DEVICE DELETE] 1 Turn the volume knob to select a device to delete, then press the knob.
2 Turn the volume knob to select [YES] or [NO], then press the knob.
[PIN CODE EDIT] Changes the PIN code (up to 6 digits).
(0000) 1 Turn the volume knob to select a number.
2 Press S / T to move the entry position.
Repeat steps 1 and 2 until you finish entering the PIN code.
3 Press the volume knob to confirm.
* You can connect a maximum of two Bluetooth phones and one Bluetooth audio device at a time.
[RECONNECT]
[AUTO PAIRING]
[INITIALIZE]
[INFORMATION]
Bluetooth compatibility check mode
You can check the connectivity of the supported profile between the
.
Bluetooth device and the unit.
• Make sure there is no Bluetooth device paired.
Default: [XX]
1
2
3
[ON]: The unit is automatically reconnect when the last connected
Bluetooth device is within the connectable range. ; [OFF]: Cancels.
[ON]: The unit is automatically paired with the supported Bluetooth
device (iPhone/iPod touch) when it is connected through USB input
terminal. Depending on the operating system of the connected device, this
function may not work. ; [OFF]: Cancels.
[YES]: Initializes all the Bluetooth settings (including stored pairing,
phonebook, and etc.). ; [NO]: Cancels.
[MY BT NAME]: Displays the name of your receiver ("KD-DB9
[MY ADDRESS]: Shows address of this unit.
Press and hold .
"BLUETOOTH" "CHECK MODE" appears. "SEARCH NOW USING
PHONE" "PIN IS 0000" scrolls on the display.
Search and select the name of your receiver ("KD-DB9
Bluetooth device within 3 minutes.
Perform (A), (B) or (C) depending on what appears on the display.
(A) "PAIRING" "XXXXXX" (6-digit passkey): Ensure that the same
passkey appears on the unit and Bluetooth device, then operate the
Bluetooth device to confirm the passkey.
(B) "PAIRING" "PIN IS 0000": Enter "0000" on the Bluetooth device.
(C) "PAIRING": Operate the Bluetooth device to confirm pairing.
BT"). ;
BT") on the
17
ENGLISH