Resetting The Base Station To Factory Defaults - Gigaset 2010 Operating Instructions Manual

14.8.98
Operating modes
Changing the system code
B
Changing the handset PIN

Resetting the base station to factory defaults

2 5 0
O
20
KAP04.FM5
# 8 *
Start setting procedure.
Enter the current system code (factory default "0000").
o
Enter the new four-digit system code. Note carefully the
o
number entered.
o
Enter the new system code again to confirm.
B
Store the setting.
8 9
B
Start setting procedure.
Enter the current PIN (factory default "0000").
o
Enter the new four-digit PIN. Note carefully the number
o
entered.
o
Enter the new PIN again to confirm.
B
Store the setting.
You can use this procedure to reset the following settings
to factory defaults:
Signaling method (DTMF/flash 300 ms)
Pause length following exchange code ( 3 seconds)
Call allocation (collective call)
The following stored data can be deleted:
Exchange code
# 1
B
Start setting procedure.
Enter the four-digit system code (factory default: "0000")
o
( page 19).
B
Reset the base station to the factory default.
Gigaset 2010, UEB/engl.: A30852-X1100-E301-2-7619
page 19
The stored system code (
leted.
All registered handsets remain registered.
page 16
page 51
page 19) is not de-