Identification Data; Data Plate Of The Device; Data Plate Of The Scaler Handpiece; Testing - mectron Piezosurgery II Use And Maintenance Manual

01.1 Identification data

An exact description of the model including the serial number of the equipment will make it easier
for our After-Sale Service to respond quickly and efficiently to your queries.
Always provide the above information whenever you contact a Mectron Service Centre.

01.2 Data plate of the device

Each device has its own data plate (Fig.1), on which its technical specifications and serial number
are indicated. The data plate is on the rear of the device. The remaining data are included in this
manual (see Section "13.0").

01.3 Data plate of the scaler handpiece

The serial number of this Piezosurgery handpiece is engraved on the ringnut (Fig.2 - Ref.A).
6
Piezosurgery // - manual of use and maintenance
01.0 Identification data
Fig. 1
A
Fig. 2

02.1 Testing of the equipment

All equipment manufactured by MECTRON is thoroughly checked and tested, including all compo-
nents.
During the testing procedure the components are subjected to a number of work cycles.
The tests highlight any malfunctioning due to faulty components.
This procedure ensures proper functioning and reliability of all components.

03.1 Delivery of the apparatus

The equipment contains electronic components that may be damaged by impacts even inside the
packaging. Special care must therefore be taken for both transport and storage.
In order to avoid crushing, do not place cartons on top of one.
All material shipped by MECTRON is checked at the time of shipment.
The equipment is delivered properly protected and packaged.
At the time of receipt of the equipment check it for possible transport damage. If any damage is
found, make a complaint to the carrier.
Piezosurgery // - manual of use and maintenance

02.0 Testing

03.0 Delivery

7