Dielectric; Measure Mode - K-TEK MT5000 Installation & Operation Manua

4.3.7. DIELECTRIC (OPTIONAL)
The DIELECTRIC setting is an optional entry. It is not used to set or establish any
operating parameters within the unit. It will not be necessary to know the exact di-
electric constant of the process or to enter a valid value in this setting.
To enter the DIELECTRIC:
1. Press and hold the SELECT button.
2. Scroll UP or DOWN to set each digit.
3. Press the SELECT button to set the digit and move to the next digit in se-
quence.
4. After the last digit is set, press the SELECT button to set the DIELECTRIC.
5. Scroll UP or DOWN to END MENU.
6. Pressing the SELECT button now will return you to the main display.

4.3.8. MEASURE MODE

The MT5000 can be used to measure Media Level or Ullage. Media Level refers to a
Level Measurement from the end of the probe to the surface of the liquid level that is
measuring the amount of liquid in the tank. Ullage refers to a Level Measurement
from the face of the coupler to the surface of the liquid that is measuring the amount
of vapor space in the tank. From the factory the MEASURE MODE will be Media
Level.
To select the MEASURE MODE:
1. Press and hold the SELECT button for 2 seconds.
2. Scroll UP or DOWN to change the MEASURE MODE between Me-
dia Level and Ullage.
3. Press the SELECT button.
4. Scroll DOWN to END MENU.
5. Pressing the SELECT button now will return you to the main display.
MT5000-0200-1 Rev f (10-2010) DCN0528
Figure 14
0%
ULLAGE
MEDIA
LEVEL
0%

DIELECTRIC

XX.XX
mA
LVL: XX.XX in XX.XX
MEASURE MODE
Media Level
mA
LVL: XX.XX in XX.XX
16