Table of Contents
Advertisement
6
ArmorBlock MaXum 8 Input / 8 Output Module
I/O connectors for this module are shown below.
Input 0
Connector A
Input 1
Input 2
Connector B
Input 3
Input 4
Connector C
Input 5
Input 6
Connector D
Input 7
Output Power and DeviceNet Cables
Output power and DeviceNet cables are described in the installation
publications for the cable base assembly of your choice. Refer to the
following publications:
• 1792D-5.9 ArmorBlock MaXum Cable Base Installation Guide
• DN-6.7.2 DeviceNet Cable Planning and Installation Manual
Communicate With Your ArmorBlock MaXum I/O Module
This ArmorBlock module's I/O is exchanged with the master through a
poll, change of state, or cyclic connection.
The module consumes and produces I/O data as follows:
Type of I/O Connections
Cyclic
Polled
Change of State
Cyclic - allows configuration of the block as an I/O client. The block will
produce and consume its I/O cyclically at the rate configured.
Publication 1792D-5.20 - October 1998
I-0
O-0
I-1
O-1
I-2
O-2
I-3
O-3
I-4
O-4
I-5
O-5
I-6
O-6
I-7
O-7
Auxiliary Power
Network Status
Module Status
Consumes
1 Byte
1 Byte
1 Byte
Output 0
Connector E
Output 1
Output 2
Connector F
Output 3
Output 4
Connector G
Output 5
Output 6
Connector H
Output 7
Produces
4 Bytes
4 Bytes
4 Bytes
41517
Advertisement
Table of Contents
