Setting Up The Handset For Use - Siemens Gigaset SL55 Owner's Manual

Setting up the handset for use

Fitting the battery pack
Caution:
Only use the rechargeable Siemens original
battery pack (page 23)! This means that you
should never use a conventional (non-
rechargeable) battery pack, as this may cause
significant damage to health and property. For
example, the outer casing of the battery pack
could be destroyed or the battery pack could
explode. The phone could also malfunction or
be damaged as a result of using batteries that
are not of the recommended type.
¤
With the pins to the front, insert the
battery pack into the cavity at an angle
from the right.
¤
Then press it into the housing from
above until the bracket on the side of
the battery back snaps securely into the
housing.
Please note:
To remove the battery pack, you must first
press the bracket on the side.
Closing the battery cover
¤
First, align the notches on the side of
the battery cover with the protrusions
on the inside of the housing.
¤
Then press the cover until it clicks into
place.
Attaching the belt clip
There are notches for attaching the belt
clip on the side of the handset at the same
height as the display.
¤
Press the belt clip onto the back of the
handset so that the protrusions on the
belt clip engage with the notches.
Opening the battery cover
¤
If fitted, remove the belt clip.
¤
Lift the device with the keypad in the
palm of your hand.
¤
Insert your index finger into the notch
on the lower edge.
¤
Carefully lift the cover upwards out of
the notches.
First Steps
5