Restoring The Handset Default; Settings; Appendix; Care - Siemens Gigaset SL55 Owner's Manual

Appendix

Restoring the handset default

settings

You can reset any individual settings and
changes that you have made. Entries in
the directory, the call-by-call list, the calls
list, the SMS lists (depending on base sta-
tion) and the handset's registration to the
base station as well as the content of My
stuff are retained.
¢ ¢
w Ð
Handset
Press the display key.
Yes
a
Press and hold (idle status).
Appendix

Care

¤
Wipe the charging cradle and the hand-
set with a damp cloth (do not use sol-
vent) or an antistatic cloth.
Never use a dry cloth. This can cause
static.

Contact with liquid

If the handset has come into contact with
liquid:
1. Switch off the handset and remove
the battery pack immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours (not
in a microwave, oven etc.).
4. Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.
22
¢
Reset Handset
!

Questions and answers

If you have any questions about using
your handset, visit us at any time at
www.siemens.com/gigasetcustomercare.
The table below contains a list of common
problems and possible solutions.
The display is blank.
1. The handset is not switched on.
¥
Press and hold the end call key
2. The battery pack is flat.
¥
Charge/replace the battery pack
(page 5).
The handset does not respond to a key press.
The keypad lock is activated.
¥
Press and hold the hash key
"Base station x" is flashing in the display.
1. The handset is outside the range of the base
station.
¥
Reduce the distance between handset/
base station.
2. The handset has been de-registered.
¥
Register the handset (page 6).
3. The base station is not switched on.
¥
Check the base station mains adapter.
Base Search is flashing in the display.
The handset is set for
tion is switched on or within range.
¥
Reduce the distance between handset/base
station.
¥
Check the base station mains adapter.
Handset does not ring.
The ringtone is switched off.
¥
Activate the ringtone (page 18).
The other party cannot hear you.
You have pressed the
set is "muted".
¥
Switch on the microphone again (page 8).
You hear an error tone when keying an input
(a descending sequence of tones).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the instruc-
tions if necessary.
a
#
(page 8).
Best Base and no base sta-
u
(INT) key. The hand-
.