Setting Up The Handset For Use - Siemens GIGASET S880 Manual

First steps
u
If you buy a replacement phone cord,
make sure that the phone jack has the
correct type of wiring.
Correct phone jack assignment
3
2
1

Setting up the handset for use

The display is protected by
a plastic film. Please
remove the protective
film!
Inserting the batteries
Warning:
Use only the rechargeable batteries recom-
mended by Gigaset Communications GmbH *
(page 31). Never use a conventional (non-
rechargeable) battery or other battery types as
this could result in significant health risks and
personal injury. For example, the batteries
could explode. The phone could also malfunc-
tion or be damaged as a result of using batter-
ies that are not of the recommended type.
* Gigaset Communications GmbH is a trademark
licensee of Siemens AG.
¤
Insert the batteries the right way
round.
The polarity is indicated in/on the battery
compartment.
6
1 unused
4
2 unused
5
3 a
6
4 b
5 unused
6 unused
Closing the battery cover
¤
First insert the battery cover at the top.
¤
Then press the cover until it clicks into
place.
Attaching the belt clip
There are notches for attaching the belt
clip on the side of the handset at the same
height as the display.
¤
Press the belt clip onto the back of the
handset so that the protrusions on the
belt clip engage with the notches.
Opening the battery cover
¤
Place your fingertip in the cavity on the
casing and pull the battery cover
upwards.