VDO DTCO 4.0 Instruction Manual page 44

Operation (general)
4
Fig. 13: Requesting card (combination button)
1. Keep the combination button
Driver 1 or Driver 2 pressed
for more than 2 seconds.
Subsequently, the display will show:
• The name of the card holder
• A status bar showing the transfer
of data onto the card chip
• The deregistration prompt
2. Use the buttons to select the de-
sired function:
• Driver card:
Selection of the country you are
currently in.
IMPORTANT
If the country is not entered within a
minute, the card ejection is terminated.
44
• Company card:
(a) Yes if you wish to deregister the
company on the DTCO 4.0.
(b) No if the company lock should stay
activated.
IMPORTANT
If the company lock is deactivated, the
saved data of your company will still be
locked for an external company.
3. Please confirm your selection using
the button .
IMPORTANT
A note is displayed in the following
cases:
• Periodic inspection of the DTCO 4.0
• Validity of the company or driver
card about to expire
• The download of the driver card data
is due.
The card feed of the corresponding slot
comes out
4. Remove the card.
5. Carefully fold up the card feed cover.
6. Push the card feed into the card slot
until it engages.
Operating instructions DTCO 4.0 - Edition 11.2018 - A2C19916900
Removing the card