Advance acoustic LIGHTNESS 3 Manual page 28

For the first step in fitting a Light speedbag release the grey adjust-
ment section at the upper ends from the two lower blue speedbag
lines. To do this loosen the kits knots of the blue speedbag lines and
pull these off the grey adjustment lines. Now fasten the two grey ad-
justment lines with kite knots direct to the black loops on the edge of
the seat surface. Then fasten both lower blue speedbag lines to the
grey adjustment lines, again with kite knots.
At the second step fix your new speedbag to the underside of the
harness with the Velcro and close both side zips
The third step requires that you hang the grey speedbag left and right
support loops in the carabiners.
Caution: Always use the original footboard (blue) lines that be-
long to the speedbag.
Caution: It is essential that the grey speedbag support loops
are hung in the carabiners. Otherwise the zips will be immedia-
tely damaged under load.
Info: The footboard is part of the speedbag and provides si-
gnificant support in your no-seatboard reclining position. The
LIGHTNESS 3 only functions with the Speedbag.
.
28