Front Handle And Wheels; Mounting Brackets And Workpiece Supports - Delta 36-267 Instruction Manual

FRONT HANDLE AND WHEELS

1. Attach handle (A) by inserting the tubes into the
top of the front folding supports. The handle
should be angled down.
2. Align holes and secure using two M8 x 20mm
self-tapping screws (B) and Phillips head
screwdriver.
3. Place a M13 (ID) x 28mm (OD) washer on each of
the fixed axles (C).
4. Slide the wheels (D) onto the axle with the wheel
collar facing in. Place a M8.2 (ID) x 25mm (OD)
washer onto the end of each axle.
5. Secure with an M8 lock nut. Rotate the nut
clockwise to tighten. Do not over-tighten.

MOUNTING BRACKETS AND WORKPIECE SUPPORTS

1. Place the mounting brackets (A) onto
the front and rear rails by engaging
the front end of the bracket on the
rail first, then lowering the rear end
over the rail.
2. Insert the workpiece supports (B)
as shown with the clamping knobs
facing out.
ASSEMBLY
B
7
B
A
C
D
B
A