Unpacking - Delta 36-267 Instruction Manual

Dust created by power sanding, sawing, grinding, drilling, and other
construction activities may contain chemicals known to the state of California to cause cancer, birth
defects or other reproductive harm. Some examples are:
– Lead from lead-based paints
– Crystalline silica from bricks and cement and other masonry products
– Asbestos dust
– Arsenic and chromium from chemically-treated lumber
• Your risk from these exposures varies depending on how often you do this type of work. To reduce your exposure to
these chemicals: work in a well-ventilated area and work with approved safety equipment, such as dust masks that
are specially designed to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with soap and water
If you have any questions or concerns relative to the use of your tool or the contents of this manual,
stop using the tool and call DELTA® Power Equipment Corporation Customer Care at 1-800-223-7278.
1. Remove all contents from the shipping carton.
2. Set aside the packing material; place the stand on the ground and lay out all loose parts and hardware.
3. Using the illustration below, locate and identify all parts and hardware to make sure they are all accounted for
before discarding packing material or beginning to assemble.
NOTE: If any part is missing or damaged, DO NOT attempt to assemble the product and call DELTA® Power
Equipment Corporation Customer Care at 1-800-223-7278.
PROPOSITION 65 WARNING:

UNPACKING

4