Operating Instructions - Central Pneumatic 95030 Set Up And Operating Instructions Manual

WARNINg! Use eye and hearing protection. Always wear ANSI-approved safety
impact glasses and full face shield when using this Polisher Kit. Also, wear ANSI
approved hearing protection. Other people in the work area must also wear ap-
propriate ANSI approved safety equipment.
1. Whenever possible, secure the workpiece in place, using a vise or clamps (not
included).
2. Prior to polishing a workpiece, make sure its surface has been thoroughly
cleaned and is free of dust, dirt, oil, grease, etc.
3. Apply about two tablespoons of wax (not included) evenly on the previously
installed Foam Pad (31). Do not apply the wax directly on the surface of the
workpiece. The amount of wax needed will vary according to the size of the
workpiece being polished. NOTE: Avoid using too much wax. For additional
applications of wax to the Foam Pad, reduce the amount of wax. The Foam Pad
will not absorb as much wax in subsequent applications. (See Figure C.)
4. Connect the air supply hose (not included) to the previously installed Quick Con-
nector on the Polisher. Always position the air hose so it will not damage the
surface being worked on. Turn on the air compressor, and set its regulator at 90
PSI. do not exceed 90 PSI. (See Figure C.)
5. IMPORTANT:
the surface of the workpiece. Failure to do so may result in the Foam Pad (31)
being thrown from the 3" Pad (29). (See Figure C.)
6. Grip the Polisher firmly with both hands. Then, squeeze the Trigger (8) to start
the Polisher. NOTE: The speed of the Polisher may be increased by turning its
Regulator (14) counterclockwise. (See Figure C.)
7. Allow the Foam Pad (31) to spin up to full speed. Then begin applying wax to the
workpiece. Apply the wax to all flat surfaces with broad, sweeping strokes in a
criss-cross pattern. Apply the wax evenly over the surface of the workpiece, and
add additional wax as needed. (See Figure C.)
8. After the wax has been applied to the workpiece surface, release pressure on the
Trigger (8) to turn off the Polisher. Turn off the air compressor. Then squeeze
the Trigger of the Polisher to release any remaining air pressure in the tool and
compressed air system. (See Figure C.)
9. Remove the Foam Pad (31) from the 3" Pad (29) of the tool. With the Foam Pad
in your hand, apply the wax to all hard to reach areas of the workpiece.
(See Figure C.)
10. Allow sufficient time for the wax to dry on the workpiece surface.
SKU 95030 For technical questions, please call 1-800-444-3353.

OPERATINg INSTRUCTIONS

Always start and stop the Polisher while it is held firmly against
PAGE 6