Alamo MACHETE Product Service Manual page 129

MOTOR P/N 02979881 - ASSEMBLY
Motor Assembly: Continued
18.
Install Relief Manifold. It would not
have been required to remove the Relief
Manifold (item 28) to disassemble the motor,
it could have been left attached to the Barrel
Housing Assembly (item 1) . If it was re-
moved, inspect the O-Rings (item 31) and
replace if nessacary. The reliefs (item 29 &
30) would not have had to be removed, but if
they were make certain to replace them the
same way they were removed, there is a
Relief Valve Seal Kit (See item 28) available
as repair parts. (See Figure 37)
19.
Inspect all assembly steps done and
make certain every thing is clean, all opening
should be plugged and remain plug until
hoseconnections are attached.
20
If only replacing Seal as a repair See
Figure 8 & 9 in disassembly section and
Figures 24, 25, 26 & 27 in the assembly
section.
It will be required to remove Seal
Carrier Retaining Ring, Pull Seal Carrier out
of pump Bearing Housing and remove seal
from seal carrier. Make certain to check the
O-Ring Seal under seal carrier, it should be
replaced when seal carrier is removed and
reinstalled. Reverse procedure to reinstall
seal carrier. (See Figure 38 & 39)
25
6
Figure 35
Machete (Service Manual) 04/04
© 2004 Alamo Group Inc.
1
25
Figure 33
This side down against Cylinder Barrel
2
Figure 34
Figure 36
129
2
1
25