Alamo MACHETE Product Service Manual page 122

MOTOR P/N 02979881 - DISASSEMBLY
Motor Disassembly: Continued
Remove Seal Carrier . Using small
8.
tool lift seal carrier (item 9) up and slide it off of shaft
as shown in Figure 9.
9.
Remove sealing O-Ring. There is an O-
Ring (item 8) under seal carrier that you can reach
and pull out. (See Figure 10)
Remove External Snap Ring From
10.
Looking down on the shaft as shown in Figure 11,
there are spacer washers (items 11, 13 & 22) and
external snap ring. Make certain to make a note of
where they are located and how many there are.
Use snap ring pliers to remove retaining ring, do not
pry it off of shaft as this would scratch the shaft.
11.
Remove Spacer Washer. Under the Snap
Ring. Remove any spacer washer under the snap
ring, noting their quantity and location. (See Figure
12). Make certain to keep all Spacers in the same
order they came off.
Splined
Shaft
23
Figure 11
Machete (Service Manual) 04/04
© 2004 Alamo Group Inc.
Splined Shaft
pry
Small Pry
Tool
Shaft,.
Figure 9
Splined
Shaft
Figure 10
Splined
Shaft
11, 13, 22
Figure 12
122
9
8