Alamo MACHETE Product Service Manual page 109

MOTOR P/N 02967193 - ASSEMBLY
.002"
.007"
FIGURE 72
11. Hold Valve Plate firmly in position. Install
End Cover on Housing. (Figure 73)
12. Install Cap Screws in End Cover, Slowly
and evenly in a star pattern tighten them.
Torque Cap Screws to 39 ft. lbs. Then a
second time go back and recheck Torque
making sure they are 39 ft. lbs. (53 nm)
using the star pattern.
13. IMPORTANT: Get the New Shaft Seal.
The New Shaft Seal is coated with a Rust
Preventative that MUST be removed be-
fore installation. Clean the Seal Parts
with a suitable solvent then Blow Dry. The
Metal to Metal Sealing Surfaces are
CRITICAL; The Solvent MUST EVAPO-
RATE without leaving a residue. DO NOT
touch the Sealing surfaces after clean-
ing.
14. Lubricate Inner O-Ring of Rotating Seal.
Then install Rotating Seal with Seal Puller
(Owatonna Tool Co. No. CAS-1844).
Ensure that Rotating Seal O-Ring is
placed inside the Rotating Seal before
assembling onto the Drive Shaft.
15. Lubricate O-Ring Seal of Stationary Seal assembly (Figure 74). Then install Stationary Seal
Assembly .
16. Use a No. 5 or No. 7 retaining Ring Pliers to install Retaining Ring, Be Sure to install Retaining
Ring with Beveled Side Out.
Machete (Service Manual) 04/04
© 2004 Alamo Group Inc.
Magnetic
Base
Indicator
Final Assembly
with Valve
and Bearing
Plates
FIGURE 73
Retaining Ring
O-Ring
Seal Puller
FIGURE 74
109
Valve Plate
Held Firmly
in position
Brg Plate
Standrard End Cover
or Integral Shuttle &
Low Pressure Relief
End Cover, Install the
same
Stationary Seal Asy.
Inner O-Ring
Valve Plate
Rotating Seal