Scooter Tiller Controls (Fig. 11A&B); Speed Controls; Battery Level Indicator/Gauge; Lights - Shoprider SUNRUNNER 3 888B-3 User Manual

SCOOTER TILLER CONTROLS (FIG. 11A&B)

Speed Controls

The speed control allows you to set a speed between 1 (minimum) and 10 (maximum).
Battery Level Indicator
The number of LED bars lit, shows the amount of charge left in your batteries. The amount of
charge will only show at its true level when the scooter is in drive.
Caution – Do not allow the LED bars go out completely as complete discharge of the batteries

Lights

A blue colored button at the rear of the tiller operates the lights.

Horn

A yellow button at the rear of the tiller operates the horn.

Thumb/Finger Lever Controls

The left thumb/finger lever controls the reverse and the right thumb/finger lever controls the
forward motion. The amount of pressure applied to each lever will determine the speed the
scooter travels at. Release the lever and the scooter will slowly come to a stop and the
electromagnetic brake will be applied.

On/Off Key Switch

Insert the key in the right side of the tiller. Turn the key and the LED bars will light up. There is
a delay before the thumb/finger lever control can be operated, while the controller is checking
the circuits.

Indicator Switch

Operates turn indicator lights.

Hazard Warning Switch

A red button operates all indicator flashers.
6/1/2007
could cause irreversible damage.
Speed
Controls
Battery Level
Indicator
Horn
Figure 11A
Battery Level Indicator
10
Key Switch
Thumb Lever
Control
Light
s
Indicator
Switch