Igintor; Thermostat - Daesung Celtic SHW-13 Installation Manual And Owner's Manual

7. IGNITOR REPLACEMENT
1. Refer to Frame 2.
Remove the 2 screws to separate
2.
the ignitor fromthe fan.
Fit the new ignitor.
3.
Reassemble in reverse order.
4.
5. Check the operation of
the water heater. Refer to Frame 2.
8. THERMOSTAT REPLACEMENT
1. Refer to Frame 2-3.
2-1. Hot water temperature sensor.
- Turn counterclockwise to separate the sensor.
2-2. Hot water outlet temperature sensor.
- Turn counterclockwise to separate
the sensor.
Cold water inlet temperature sensor.
2-3.
- Remove the 1 screw to separate
the sonsor from the water control
valve.
3. Fit the new sensor
4. Reassemble in reverse order.
5. Check the operation of the water heater.
Refer to Frame 2-3
Remove the 2 screws to separate the
ignitor from the fan.
Hot water
temperature
sensor
Hot water outlet
temperature
sensor
Turn counterclockwise to separate the sensor.
Cold water
inlet
temperature
sensor
Remove the 1 screw to separate the sonsor
from the water control valve.