16.
Multi Remote Controllers
※ General Installation of multiful controller, it is changeable depends on
options of installation field and client requirements.
There may have a variation on installation field or client
but be sure to keep the length in the manufacturer recommendation.
Before Installing the multiful controllers, make sure to turn the power off.
※ The number of Remote-controllers for the multi-mode is the Maximum 4.
The multiful controllers can be installed for a water heater.
Controllers can only be wired in parallel, do not wired in series.
Setting method of each Remote controller
1. Water heater pluged and controller off for the setting.
Press "
s "
s "
s "
s "
s "
s "
" + "
" + "
" + "
" + "
" + "
" + "
" + "
2. Please check "℃"on the display, as the below picture.
Press "
s "
" b
" button until display shows "ID1" on the display.
3. Put the ID on each controller among digits 1~4,
with "
h "
h "
h "
" , "
" , "
" , "
" , "
Be sure that each controller ID does not be repeated.
Press "
s "
" b
" button to finish the setting.
20m
20m
" t
" t
" t
" t
" t
" t
" the buttons at once in seconds
"
"
"
" button.
request,
20m
20m
Hold it
down
for 3sec.