Unit Installation - Daesung Celtic SHW-13 Installation Manual And Owner's Manual

Consult with the customer concerning the location of installation.
Avoid places where fires could occurs, shch as those where gasoline
benzene and adhesives are handled, or places in which corrosive gases
(ammonia, chlorine, sulfur, ethylene compounds, acids) are present.
This may cause incomplete combustion or other component failure.
Locate the vent terminal so that there are no
obstacles around the termination and so that
exhaust products cannot accumulate.
Do not enclose the vent termination with
corrugated metal or other materials.
Install the water heater in area that allows
for the proper clearances to combustible
and noncombustibles.
Consult the installation manual for proper
clearances required.
Do not install the water heater in a place
where it may be damaged by falling objects.
The water heater must be installed in a place
where supply and exhaust vent pipes can
be installed as directed.(Internal model)
Do not install the water heater where the
exhaust gas will vent onto walls or material
not resistant to heat.
Do not vent directly onto trees & shrubs nor
where animals may congregate.
The heat and moisture from the water heater
may cause discoloration of walls and resinous
materials, or corrosion of aluminum materials.
Avoid installation in places where dust or debris
will accumulate.
Dust may block the air-supply opening,
causing the performance of the fan motor
to drop and incomplete combustion to occur as result.
Install in a location where the exhaust gas flow will not be affected by fans
or range hoods.
Ensure that noise and exhaust gas will not affect neighbors.
Avoid installation in places where special chemical agents (e.g. hair spray
or spray detergent) are used.
Ignition failures and malfunction may occur as a result.