Model C-6000 Series Command Center - Instructions - GAYLORD CG3 Series Technical Manual

MODEL C-6000 SERIES COMMAND CENTER - INSTRUCTIONS

• Press [F5], the EXIT button to exit the Menu
• Press [F6], the ENTER button to select a Menu item
1. Service
• Press [F6] [ENTER] to display Gaylord's web site
address: gaylordusa.com
• Press [F5] [EXIT] to return to the menu
2. Detergent
• Press [F6] [ENTER] to display the Phone Number to
order Detergent: 800-286-2010
• Press [F5] [EXIT] to return to the menu
3. Wash Length
• Press [F6] [ENTER] to display the Length of Wash #1
• Press [F3] to Increase the Wash Time up to 9 Minutes
(Maximum)
• Press [F4] to Decrease the Wash Time down to 3
Minutes (Minimum)
• Press [F1] to adjust the Length of Wash #2 (if applicable)
• Press [F5] [EXIT] to return to the menu
• Note: Press [F1] to advance through all washes (ex.)
"-S2" has 2 washes)
4. Delay Time
• Press [F6] [ENTER] to display the Delay Time between
washes (Not used if there is only one wash)
• Press [F3] to Increase the Delay Time up to 99 Minutes
(Maximum)
• Press [F4] to Decrease the Delay Time down to 1 Minute
(Minimum)
• Press [F5] [EXIT] to return to the menu
5. Set Clock
• Press [F6] [ENTER] to display the current Day of the
Week (1=Sunday)
• Press [F3] to change to the next Day of the Week
(1=Sun, 2=Mon, 3=Tues, etc.), keep pressing [F3] to
cycle around if necessary
• Press [F1] to go to the current Hour
• Press [F3] to increase the Hour, keep pressing [F3] to
cycle around if necessary
• Press [F1] to go to the current Minute
• Press [F3] to increase the Minute, keep pressing [F3]
to cycle around if necessary
• Press [F5] [EXIT] to return to the menu
6. AutoMode [A or M]
• Used to select [M]anual or [A]utomatic mode. If [A] is
displayed, the C-6000 is set to operate in Automatic
mode. If [M] is displayed, the C-6000 is set to operate in
Manual mode.
• Press [F6] [ENTER] to display the "Set Mode" screen
• Press [F6] [ENTER] again to toggle between [M]anual
or [A]utomatic mode
Setting Which Days of the Week to Run:
• Press [F1] to select which days to run the C-6000 in
Automatic mode
• "Sun ON" or "Sun OFF" will display
• Press [F3] to set a day to "ON". Set a day to "ON" in order
for the C-6000 to run on that day
• Press [F4] to set a day to "OFF". Set a day to "OFF" in
order for the C-6000 NOT to run on that day
• Press [F1] to cycle through each day of the week [Sun
– Sat.]
• Press [F5] [EXIT] to return to the menu
7. Set WashTimes
• Only used when C-6000 is set to Automatic mode
• Press [F6] [ENTER] to display the Start time for the Fan
on Sunday (Sun. Fan)
• Press [F3] to increase the Hour
• Press [F4] to increase the Minutes
• Press [F1] to go to the Start time for the Wash on
Sunday (Sun.Wash)
• Set the time, using the same method described above
• Press [F1] to cycle through for each day of the week, for
the Start Times for the Fan and Wash
• Press [F5] [EXIT] to return to the menu
8. Wash Test
• Press [F6] [ENTER] to run the C-6000 through a
complete Wash cycle with decreased times
• After the Wash Test is complete, the C-6000 will return
to the Fan Off mode
9. Number of Washes
• Pressing [F6] [ENTER] will prompt for a password
It is not necessary to change this value. It is preset at
the Factory.
TIME CLOCK OPERATION
AutoMode is used to have C-6000 start the exhaust/supply
fans automatically, once per day. The AutoMode also stops
the fans and starts the wash cycle, once per day.
To use the AutoMode:
1. Set Wash Length(s) (Menu item #3)
Set length of each wash cycle, from 3 minutes to 9
minutes
2. Set Delay Time between washes, if control has more
than one wash solenoid (Menu item #4)
Set amount of time to wait between washes, from 1
minute to 99 minutes
3. Set Clock (Menu item #5)
Please note that the clock is a 24-hour clock.
Example: 1:00 PM = 13:00
Set the current day of the week.
Example: 1 = Sun. 2 = Mon. 3 = Tues, etc.
4. Turn AutoMode ON (Menu item #6)
Pressing (F6) Enter will toggle between [A]utomatic
and [M]anual modes
After it is set to [A]utomatic mode, set which days of the
week the Exhaust/Supply Fan will run - setting a day to
"ON" means the Exhaust/Supply Fan will start on that
day, and the Wash will run.
Example:
5. Set Wash Times, set start times for Fans & Wash
(Menu item #7).
Set the time for the Fans to Start for each day of the week.
Example:
Set the time for the Wash to Start for each day of the week.
Example:
15
Sun ON
Mon OFF
Tues ON
Sun. Fan 5:00
Mon.Fan 5:00
Sun.Wash 22:00
Mon.Wash 22:00