Table of Contents
Advertisement
HOT KEY
When this function is ON, BRIGHTNESS, VOLUME, USB SELECTION and MULTI PICTURE settings can be changed
without opening the OSD menu.
ON:
BRIGHTNESS: Touch the UP key, then adjust the brightness level in the sub-menu that opens.
VOLUME: Touch the DOWN key, then adjust the volume level in the sub-menu that opens.
USB SELECTION: Touch the RIGHT key to open the USB SELECTION sub-menu.
MULTI PICTURE: Touch the
between a main screen and a sub-screen by touching the
is set in MULTI PICTURE
OFF: The HOT KEY function for the "
SIGNAL INFORMATION
If you select "ON", the monitor displays "VIDEO INPUT MENU" after changing the input.
If you select "OFF", the monitor doesn't display "VIDEO INPUT MENU" after changing the input.
SENSOR INFORMATION
If you select "ON", the monitor displays a "HUMAN SENSOR ON" message. If you select "OFF", the monitor doesn't
display the "HUMAN SENSOR ON" message.
KEY GUIDE
If you select "ON", the Key Guide appears on screen when the OSD menu is opened.
DATA COPY
To initiate data copy from the master monitor to the sub-monitor(s), select "DATA COPY" and touch "SELECT".
A "PROCEEDING..." indicator will appear on the screen.
NOTE: This function is only intended for the master monitor in ControlSync.
All of the settings specified in the ControlSync chart (see
monitor to the sub-monitor(s).
CUSTOMIZE SETTING
Store the current settings for easy recovery.
To store current settings: Touch "SELECT". After a warning message appears, touch "RESET" and the current
settings are stored.
To restore settings: Hold "MENU" for 3 seconds or more when the OSD menu is closed.
MULTI DISPLAY
MONITOR NO.
This function is for INDIVIDUAL ADJUST.
Sets a monitor number for each monitor.
Control a sub-monitor from the master monitor by INDIVIDUAL ADJUST:
This function is for controlling a sub-monitor from the master monitor. It is useful if the sub-monitor is located at an
unreachable spot.
Please set the monitor number for each monitor. If you set a unique number to each of the monitors, you can control a
specific monitor. If you set duplicate numbers to some of the monitors, you can control the monitors that have the same
number simultaneously.
NOTE: A master monitor should be connected only with ControlSync OUT. Do not connect a master monitor
with ControlSync IN. For information about master and sub-monitors, see ControlSync
180° ROTATE
The image rotates 180 degrees.
NOTE: When installing monitors in two stages, upper monitors can be installed upside down.
The installation method can minimize bezel distance between upper monitors and bottom monitors.
[180° ROTATE: OFF]
[180° ROTATE: OFF]
/RESET key to open the MULTI PICTURE sub-menu. You can swap pictures
/RESET" key, "LEFT/RIGHT" key and "DOWN/UP" key functions are disabled.
[180° ROTATE: ON]
[180° ROTATE: OFF]
Monitor 1
A
English-20
/RESET key for 3 seconds or more while Main or Sub
page
12) will be copied from the master
Monitor 2
A
Monitor 1
A
(page
11).
Hide quick links:
Advertisement
Table of Contents
