Operating Instructions - American Sanders EZ Sand-HDTR Operator's Manual

Section - A
Follow this procedure for sanding floors:
1. Move machine to work location. Decide the best
approach to sanding the desired area. When sanding
the area, work so that you are moving away from the
power supply. This will help to avoid entanglement
with the power cord and reduce the need to move the
power cord as frequently.
2. Install the sandpaper. Use the same procedure
outlined in MACHINE SETUP to install the sandpaper.
The sandpaper uses a hook and loop system which is
identical to how the pads attach to the drivers. Center
the sandpaper over the driver and press it against the
driver until the grip face has set into the sandpaper.
WARNING:
Injury can occur if the machine is connected to
a power source while installing the sandpaper.
Disconnect the machine before installing the
sandpaper.
3. Connect the machine to an appropriately fused and
grounded circuit.
4. While holding the handle, reach down and slide the
knurled locking collar up the handle tube and hook
it to the pin in the tube by rotating it (See Figure 7).
Lower the handle down to a comfortable position.
5. To run the machine, push the interlock button (See
Figure 8 - "1"), and apply pressure to the levers (See
Figure 8 - "2"). To stop the machine, release the
levers (See Figure 8 - "2").
CAUTION:
To prevent damage to the flooring and to reduce
swirling, keep the machine in motion while the motor
is running.
NOTE: For sanding cuts and sandpaper, see page A9

Operating Instructions

10
Figure 7
2
1
Figure 8
English - EN
2