1MRK 500 127-UEN D
GUID-8A573707-899E-4F4C-B20A-931D1556F480 V1 EN-US
Figure 27: Last digit is active and it can be increased or decreased
2.
Press
One press increases or decreases the value by a certain step. For integer values, the
change is 1, 10, 100 or 1000 (...) depending on the active digit. For decimal values, the
change can be fractions 0.1, 0.01, 0.001 (...) depending on the active digit.
3.
Press
4.
To select the minimum or maximum value, select the arrow symbol in front of the value.
•
•
If the value is already at either end value (minimum or maximum), it requires two presses
to change it to the opposite end value.
After pressing
versa. Another press of
front of the value is ↕, when the previous value is shown.
670 series
Operation manual
to increase or
to decrease the value of an active digit.
For parameters with defined steps, digits smaller than the step value
cannot be edited.
or
to move the cursor to another digit.
To set the value to the maximum, press
To set the value to the minimum, press
, the previous value can be restored by pressing
or
IEC13000285-1-en.vsd
.
.
sets the value to the lower or higher limit. The symbol in
Section 5
Using the HMI
once, and vice
41