Table of Contents
Advertisement
(Items 715 to 721: Settings for controlling the video processing system according to the menu settings.)
Item number Item name
715
VIDEO GAIN CONTROL
716
CHROMA GAIN
CONTROL
717
CHROMA PHASE
CONTROL
718
SETUP LEVEL
719
SYSTEM PHASE SYNC
720
SYSTEM PHASE SC
721
Y/C DELAY
Note
When you make settings for items 715 to 721, set the
PROCESS CONTROL switch on the subsidiary
Item number
Item name
726
H BLANKING WIDTH
728
OUTPUT SCH PHASE
Menu items in the 700s, relating to video control (Continued)
Settings
Adjust the video output level.
Default value: 800H
Adjust the chroma output level.
Default value: 800H
Adjust the chroma phase.
Default value: 80H
Adjust the setup level (black level).
Default value: 110H
Adjust the SYNC control on the subsidiary control panel.
Default value: 80H
Adjust the SC control on the subsidiary control panel.
Default value: 0H
For playback from an analog Betacam cassette, adjust the Y/C delay.
Default value: 800H
Menu items in the 700s, relating to video control (Continued)
Settings
Select the horizontal blanking width of a video output signal.
NARROW : Digital blanking (narrow)
WIDE: Analog blanking (wide)
When analog blanking is selected, the horizontal blanking width complies with
RS170A, and normally the blanking is widened and the image becomes narrower.
It is recommended to select NARROW at the editing stage, then later, for
broadcast transmission to select WIDE, to output a signal conforming to the
standard.
Set the subcarrier H phase.
Default value: 800H
control panel to MENU. When set to MENU, all
controls on the subsidiary control panel are disabled.
6-17
Chapter 6 Menu System
Advertisement
Table of Contents
