Table of Contents
Advertisement
6-3 Extended Menu
Item number Item name
606
TC OUTPUT SIGNAL IN
REGEN MODE
616
SDTI-CP OUTPUT LTC
OVERRIDE (only when
the BKNW-124 is
installed)
Item number Item name
703
BLANK LINE SELECT
Sub-Item
0
ALL LINE
In 525 mode
12 ...
LINE 12 ... LINE
19
19
20
LINE 20
9 ...
LINE 9 ... LINE 22 Specify blanking for lines 9 to 22.
In 625 mode
22
23
LINE 23
705
EDGE SUBCARRIER
REDUCER MODE
6-14
Chapter 6 Menu System
Menu items in the 600s, relating to the time code generator
Settings
Select the signal output from the TIME CODE OUT connector during normal (x1)
speed playback.
TAPE : The playback time code signal is output without regeneration.
REGEN: The playback time code is output after regeneration.
Specify whether or not the LTC signal is inserted into the time code (MPEG2
video elementary stream editing information time code) in the MPEG stream
within the SDTI-CP output signal.
DIS : The LTC signal is not inserted.
ENA : The LTC signal is inserted.
Menu items in the 700s, relating to tape protection
Settings
Switch blanking on or off for individual lines in the vertical blanking interval. The
Y/C signal and odd/even fields are blanked simultaneously.
Note
For playback of an analog Betacam cassette (Betacam SP, etc.) regardless of the
setting of this item, the chrominance signal is blanked up to line 15.
- - - : Specify the blanking for each line separately.
BLANK: Regardless of the setting of other sub-items, blank all lines which can be
specified in this menu item.
THROU: Regardless of the setting of other sub-items, switch off blanking for all
lines which can be specified in this menu item.
Specify blanking for lines 12 to 19.
BLANK : Carry out blanking.
THROU: Switch off blanking.
Specify blanking for lines 20.
BLANK : Carry out blanking.
HALF: Carry out half-blanking.
THROU: Switch off blanking.
BLANK : Carry out blanking.
THROU: Switch off blanking.
Specify blanking for line 23.
HALF : Carry out half-blanking.
THROU: Switch off blanking.
During playback, in the playback circuit the edge subcarrier reducer (ESR) is
automatically switched on or off according to the operation of the unit. If the color
edges are not as good as with a proper signal, the ESR can be forced on. This
item makes this selection.
AUTO : ESR is switched on and off automatically.
ON: ESR operation is forced on.
Advertisement
Table of Contents
