Table of Contents
Advertisement
3-3 Superimposed Character Information
When the CHARACTER switch on the subsidiary
control panel is set to ON, the video signal output from
the COMPOSITE VIDEO OUTPUT 3 (SUPER)
connector or the SDI OUTPUT 3 (SUPER) connector
contains superimposed character information,
including time code, menu settings, and alarm
messages.
Information displayed
1 Types of time data
T C R . 2 3 : 5 9 . 4 0 . 1 8 *
S H U T T L E
Note
The display shown above corresponds to the factory
default settings of the unit.
Changing the setting of basic menu item 005 allows
different time data to be displayed in the bottom line of
the display.
For details of the basic menu, see Section 6-2-1, "Items in
the Basic Menu" (page 6-1).
Adjusting the character display
You can adjust the position, size and type of the
superimposed characters using the basic menu.
For details of the basic menu, see Section 6-2-1, "Items in
the Basic Menu" (page 6-1).
2 Drop frame mode of time code reader
(for 525 mode only)
3 Drop frame mode of time code
Time data
generator (for 525 mode only)
S T I L L
5 Operation mode
1 Types of time data
Display
CTL
TCR
UBR
TCR.
UBR.
IN
OUT
AI
AO
DUR
Note
If the time data or user's bits cannot be read correctly,
they will be displayed with an asterisk. For example,
"T*R", "U*R", "T*R." or "U*R.".
4 VITC field
Meaning
CTL counter data
LTC reader time code
LTC reader user's bits
VITC reader time code
VITC reader user's bits
STUNT IN point
STUNT OUT point
PLAY IN point
PLAY OUT point
Duration between any two of the four DMC
playback control points (STUNT IN, STUNT
OUT, PLAY IN, PLAY OUT)
Chapter 3 Preparations
3-5
Advertisement
Table of Contents
