Sony Betacam SX DNW-A65 Operation Manual page 24

2-2 Connector Panel
3 Digital output section
SDI SDTI
OUTPUT
1
OUTPUT
2
1
3
2
(SUPER)
1 SDI OUTPUT connectors
1 SDI (Serial Digital Interface) OUTPUT
connectors (BNC type)
These output D-1 format digital video/audio signals.
When the CHARACTER switch on the subsidiary
control panel is set to ON, connector 3 (SUPER)
outputs a signal with superimposed time code, menu
settings, alarm messages, and other text information.
2 SDTI (Serial Data Transport Interface)
OUTPUT connectors (BNC type) (for optional use)
These output SDTI (SX) or SDTI-CP video and audio
signals.
Using these connectors requires the optional BKNW-
118 SDTI (SX) Output Board or BKNW-124 SDTI-CP
Output Board.
2-16
Chapter 2 Location and Function of Parts
2 SDTI OUTPUT connectors
4 Time code output section and audio
monitor signal output section
1 TIME CODE OUT connector
TIME CODE
OUT
MONITOR OUTPUT
R L
2 MONITOR OUTPUT connectors
1 TIME CODE OUT connector (XLR 3-pin, male)
This outputs a playback time code.
By setting extended menu item 606, you can also
output the time code from the internal time code
generator locked to the playback time code.
2 MONITOR OUTPUT connectors (XLR 3-pin,
male)
According to the setting of the audio signal selection
buttons (see page 2-2) on the upper control panel, two
(L and R) audio monitor signals are output.
5 Digital audio output section
AUDIO OUTPUT (AES/EBU) connectors
AUDIO OUTPUT(AES/EBU)
CH1/2
AUDIO OUTPUT (AES/EBU) connectors (BNC
type)
Output up to two sets (4 channels: channels 1/2 and
3/4) of AES/EBU format digital audio signals.
CH3/4