Preparations For Playback; Switch Settings; Time Data Selection - Sony Betacam SX DNW-A65 Operation Manual

4-1 Preparations for Playback

4-1-1 Switch Settings

Before beginning playback, make any necessary
switch settings.
Audio signal selection buttons (see page 2-2) :
select the audio channel(s) to be monitored
POWER switch: ON
PB controls (see page 2-2) :
adjust the audio playback levels

4-1-2 Time Data Selection

Displayed time data
Use the CTL/TC/UB button to select one of CTL
(control), time code, and user bit values. When you
select time code, the data displayed is determined by
the setting (LTC/AUTO/VITC) of the TC switch as
follows.
TC switch setting Displayed data
LTC LTC recorded on tape
VITC recorded on tape
VITC
LTC or VITC (automatically switched)
AUTO
For details of the settings of each of the switches, refer to
the pages indicated in parenthesis.
TC switch (see page 2-3) :
select the time code to be displayed
VI TC UB INTRP A IN DF LTC VITC 8F 4F 2F CONFI ON
DOLBY
A OUT TCG TOTAL REMAIN 525 625
NR
EVENT
%
CTL/TC/UB button (see page 2-4) :
select the time data to be displayed
Output time code
The setting of the extended menu item 606 determines
whether the time code output from the TIME CODE
OUT connector is the time code read by the internal
time code reader (REGEN), or the playback time code
(TIME).
For details of the extended menu item 606, see page 6-14.
REMOTE1(9P)/2(50P)
buttons (see page 2-3) : off
4-1
Chapter 4 Playback