Table of Contents
Advertisement
6-2 Basic Menu
Resetting the menu settings to their
factory default values (menu item B20)
6
0
SET button
1
Set menu item B20 RESET SETUP to ON.
"PUSH SET BTN" appears in the time data display
area 1 and 2, and "Push SET button" appears on
the monitor screen.
2
Press the SET button.
The current active menu settings (see page 6-8) are
reset to their factory default settings.
3
Press the SET button again.
The settings are saved and the menu display
disappears from the time data display area.
Switching between 525/625 line systems
(menu item 013)
Using the following procedure, you can set basic menu
item 013, 525/625 SYSTEM SELECT, to "ON", and
then switch between 525 (NTSC) and 625 (PAL).
Notes
• Before carrying out this operation, consult the person
responsible for the installation.
• When you use an external video reference signal after
you switch between 525 and 626 systems, make sure
that it corresponds to your new system.
..........................................................................................................................................................................................................
1) A monitor connected to the COMPOSITE VIDEO
OUTPUT 3 (SUPER) connector or the SDI OUTPUT 3
(SUPER) connector
6-6
Chapter 6 Menu System
%
9
)
p
Time data display
Note on using the DNW-A65 in 625 mode
If you switch to 625 mode, Betacam and Betacam SP
format can be played back in 625 mode, but only in the
simple playback mode.
Note on using the DNW-A65P in 525 mode
If you switch to 525 mode, Betacam and Betacam SP
format can be played back in 525 mode, but only in the
simple playback mode.
1
Select menu item 013.
The time data display and the monitor
show the following displays.
Time data display
Monitor screen
ITEM-013
525/625 SYSTEM
SELECT
OFF
1)
screen
Advertisement
Table of Contents
