Rentokil Connect AutoGate Instruction Manual page 9

Setting the AutoGate
Push the button to scroll through the menu in order to set the AutoGate. The
AutoGate is only successfully set when the
When the "Technician Setup"
up/down/up to test the motor and door sensors. If there is an error then E4 will
be displayed on the display.
After successfully testing the door the display will show 2 dots to indicate that it is
ready to test the sensors as shown below.
Instruction Manual Connect AutoGate/ 2017 Version 0.4 (GSD-100548)
indicator is displayed.
is selected then the door will move
Ready to test sensors.
Move hand in front of the Bait side sensor and the middle bars
will be displayed as shown.
Move hand in front of the right hand Entry side sensor and right
bar is displayed as shown.
Move hand in front of the left hand Entry side sensor and left bar
is displayed as shown.
Once all 3 sensors have been tested (in any order) the radio will
scan for connection to a Control Panel. If connected it will display
"r" and a number. The number is the signal strength from 0-9.
E.g. "r8" as shown. If there is no connection only the "r" will be
displayed while scanning.
Once the Gate is tested and connected to the Control Panel the
ON symbol is lit as shown.
Page 9