Advanced Settings - Rentokil Connect AutoGate Instruction Manual

Advanced Settings

Depending on customer or country requirements it may be necessary to turn on/off or
reduce the intensity of the external LED to avoid unwanted attention or to adjust the
number of days that the gate remains open before closing again.
NOTE: The external LED is set to OFF as default.
Adjusting the External LED
External LED
The LED can be set to Low, Medium, High or OFF. To select the required mode follow the
steps below:
1. While there is nothing on the digit display press and hold the button
2. Counter begins to count upwards from Zero
3. Once the counter has passed '10' release the button
4. Counter now shows either 0,1,2,3 (Off, low, Medium High)
5. Press the button to scroll through and choose a setting
6. The external LED will show the current setting
7. Release the button and wait 5 seconds for the setting to be stored
Adjusting the Gate open time
Once the door has opened and the bait exposed the time to which the door is closed can be
modified from the default setting of 5 days. This can be set by following these steps:
1. While there is nothing on the digit display press and hold the button
2. Counter begins to count upwards from Zero
3. Once the counter has passed '5' but not yet reached '10' release the button.
4. Counter now shows a number between '0 – 30' (Note: 0 means that the gate will stay
open and 1 to 30 is the number of days that it will stay open.
5. Press the button to scroll through and choose the required setting
6. Release the button and wait 5 seconds for the setting to be stored.
Page 12
Instruction Manual Connect AutoGate/ 2017 Version 0.4 (GSD-100548)