Signal Strength Test - Rentokil Connect AutoGate Instruction Manual

Checking the AutoGate
When the AutoGate is visited there are two options to check the functions:
Checking without resetting the AutoGate:
If the AutoGate is open when visited then it is possible to verify the number of days
that the gate has been open, the number of rodent visits, battery percentage by
pressing the button. The LED will also be lit (see below) in the case that the
AutoGate is armed and in that case the full technician test is not required.
If the technician test is not carried out then the #Days and #Rodents counts on the
display will not be reset and the gate will close as expected after the programmed
number of open days.
Checking with a Service Reset:
If the AutoGate is closed when visited then it is recommended to do a full technician
test. In this case scroll down to the position and carry out the technician test.
This will reset the #Days and #Rodents counts on the display to zero.

Signal Strength Test

When finding a good position to place the bait box and AutoGate it is possible to
run a signal test where the signal strength is shown every 2.5 seconds on the
display.
Scroll to the position until the two dots are displayed (shown blow). Press the
button and the AutoGate will start Signal Strength test mode. Press the button again
to return to the technician test. Note: This mode will timeout after 2 minutes.
In signal strength test mode, a value between "r0" and "r9" will be displayed.
AutoGates should not be deployed when the signal strength shows "r0" and
installing another Control Panel would be advised.
Page 10
Instruction Manual Connect AutoGate/ 2017 Version 0.4 (GSD-100548)