Introduction; Safety Compliance - Hayter Motif 41 Push Owner's Handbook Manual

INTRODUCTION

Thank you for purchasing a Hayter mower.
The following pages are designed to help you gain safe and effi cient service from your machine.
This Owner's Handbook should be regarded as part of the mower as it gives essential information
regarding safety, operation, maintenance and specifi cations.
If you misplace your Owner's Handbook, contact your local Hayter authorised dealer for a
replacement. Alternatively, visit www.hayter.co.uk/handbooks to download an electronic version.
For engine details related to your product, please refer to the engine handbook provided.
To ensure maximum safety, best performance, and to gain knowledge of the mower, it is essential
that you and any other operator read and understand the contents of this handbook before the
engine is started. If you are unsure of any procedure detailed in this Handbook then please
contact your local Hayter dealer for assistance.
Pay particular attention to the safety alert symbol which means Caution, Warning, or Danger.
Read and understand the instruction as it is relates to safety.
Improper maintainence or use of this mower can result in injury.
To reduce the potential for injury, comply with these safety instructions. This mower should be
operated, serviced and repaired only by persons who are familiar with its particular characteristics
and who are acquainted with the relevant safety procedures.
Throughout this handbook all references to left and right are as viewed from behind the
handlebar, in the direction of forward travel.
This machine has been designed in accordance with EN ISO 5395.
Hayter Limited have designed and tested this machine for reasonably safe service; however,
failure to comply with the instructions in this handbook may result in personal injury.
This mower is designed solely for use in a domestic grass cutting environment. Use in any other
way is considered as contrary to the intended use.
Please be advised that the illustrations in this Handbook are generic and not specifi c to your
product.
Hayter Limited reserves the right to amend product specifi cations without prior notifi cation.
For a full range of products and to locate your nearest authorised sales stockist, service or parts dealer please visit our website at www.hayter.co.uk

SAFETY COMPLIANCE

To ensure low noise and vibration levels, carry out the following procedures correctly:
• To prevent overloading the engine, use the correct height of cut and ground speed
(where applicable).
• Follow the recommended maintenance instructions.
VIBRATION INFORMATION
Long term exposure to vibration while operating the machines may cause some
numbness in the hands and wrists. Wear gloves that dampen the vibration whenever you
operate the machine for an extended period of time.
Hand / Arm Vibration Level at the Operator Position measured in accordance with
European Standard EN ISO 5395.
Measured Vibration Level ahw
Uncertainty of measurement K
SOUND PRESSURE INFORMATION
Long term exposure to noise while operating the machines may cause hearing loss.
Wear adequate hearing protection whenever you operate the machine.
Sound Pressure Level at the Operator Position measured in accordance with European
Standard EN ISO 5395.
Measured Sound Pressure Level LpA
Uncertainty of measurement K
SOUND POWER INFORMATION
Sound Power Level measured in accordance with European Standard EN ISO 5395.
Measured Sound Power Level LwA
Uncertainty of measurement K
3
437
4.2 ms -2
-2
2.1 ms
437
86 dB (A)
2 dB (A)
437
93 dB (A)
2 dB (A)