Condenser Fan - Bunn JDF-2S Service & Repair Manual

SERVICE (CONT.)
Condenser Fan (all Models)
FIG. 21 CONDENSER FAN
Location:
The condenser fan is located inside the main frame
below the compressor assembly.
Test Procedure:
1. Disconnect the dispenser from the power source.
2. Disconnect the 2-pin from the fan to the main wiring
harness.
3. Check for continuity across the fan terminals.
If continuity is present as described, reconnect the
wires to the fan terminals.
If continuity is not present as described, replace the
fan.
Removal and Replacement:
JDF-4S shown
1. Disconnect the dispenser from the power source.
2. Remove the four screws attaching the fan and cover
3. Gently pull the cover assembly forward and discon-
4. Remove the fan from the cover assembly and dis-
5. Install the new fan onto the cover assembly.
6. Reconnect the wiring harness to the new fan.
7. Install fan and cover assembly using four screws
8. Reconnect power to the dispenser.
P1684.40
24
assembly to the refrigeration cabinet.
nect the 2-pin connector from the fan to the main
harness.
card.
previously removed.
FIG. 22 CONDENSER FAN TERMINALS
BLU/BLK
WHI
P1219
49179 110613