Dispense Platform Removal - Bunn JDF-2S Service & Repair Manual

SERVICE(CONT.)

DISPENSE PLATFORM REMOVAL

1. Remove concentrate dispense tips by turning 1/4 turn to the left, then pull straight down.
2. Lift and remove product shelf to access dispense platform(s).
3. Remove front thumb screw holding dispense platform(s).
4. Disconnect 12 pin connector above dispense platform in rear.
5. Disconnect 3/8" water line at quick disconnect.
6. Remove dispense platform(s) by pulling forward.
JDF-2S shown
The JDF-4S uses 2 of the two head dispense platforms.
FIG. 2 DISPENSE PLATFORM REMOVAL
14
49179 110613