Cabinet Fan - Bunn JDF-2S Service & Repair Manual

SERVICE (CONT.)
Cabinet Fan (all Models)
FIG. 5 CABINET FAN
Location:
The cabinet fan is located inside the dispenser cabinet
mounted in the center behind the fan guard cover.
Test Procedure:
1. Disconnect the dispenser from the power source.
2. Remove the four screws attaching the fan and cover
assembly.
3. Gently pull the cover forward and disconnect the
2-pin connector from the main wiring harness.
4. Check for continuity between the two wires on the
fan.
If continuity is present as described, the fan is operat-
ing properly.
If continuity is not present as described, replace the
fan.
Removal and Replacement:
JDF-2S shown
1. Disconnect the dispenser from the power source.
2. Remove the four screws attaching the fan and cover
3. Gently pull the cover forward and disconnect the
4. Remove the fan from the cover assembly and discard
5. Install the new fan to the cover assembly using
6. Reconnect the fan to the 2-pin connector on the
7. Install the fan and cover assembly to the cabinet
8. Reconnect power to the dispenser.
P1684.40
16
assembly.
2-pin connector from the main wiring harness.
the old fan.
screws previously removed.
main wiring harness.
using screws previously removed.
FIG. 6 CABINET FAN TERMINALS
RED
2
1
BLK
P1219
49179 110613