Figure 5.6-11: Wago 4-Pin Header; Table 5.6-13: Aib-Canbus Pin Designations - Moog 903 User Manual

903-0623-00 Rev. A
Pin connections for the WAGO connector used with the AIB-CANBUS are shown in Table 5.6-13. It is
recommended to use shielded, impedance controlled (120 ohm) twisted pair cabling to maintain signal
quality. Figure 5.6-11 shows a WAGO 4-pin header.
When installing the AIB card ensure that the white alignment dot matches the alignment dot found on the
AIB-4 card to avoid damaging card.
Note:
Cards with firmware version "A" force a can bridge reset, i.e. when can errors are detected at one end
(remote or console), the can ports at both ends are reset (bus off state) for approx. five seconds.
Firmware version "B" and above do not include a bridge reset. Cards shipped before July 2011 have
firmware version "A" code unless otherwise noted.
Focal Technologies Corp.

Figure 5.6-11: WAGO 4-Pin Header

Table 5.6-13: AIB-CANBUS Pin Designations

Pin Designation
1 CAN H
2 CAN L
3 BUS - (Ground)
4 Shield
Model 903 User's Guide, FMB-X-2.5 Version
Page 5-36