Figure 3.1-2: Remote Fmb-X-2.5 Plan View - Moog 903 User Manual

903-0623-00 Rev. A
LEDs on the front panel match those described in the console FMB-X-2.5 section and allow direct
monitoring of the optical link status (LINK), optical receive power (FO-RX), and the status (STAT) of the
on-board diagnostics. See the console FMB-X-2.5 section for more details on LEDs.
The Ethernet port supports both 10 Mbps and 100 Mbps devices on the copper link. The optical Ethernet
link through the multiplexer is 100 Mbps.
Diagnostics for the FMB-X-2.5 can be accessed at the RS-232 port on both remote and console cards,
and also via the RJ-45 Ethernet port at both remote and console ends. See console FMB-X-2.5 for more
information about diagnostics.
A plan view of the remote FMB-X-2.5 is shown in the figure below. The 1310/1550 nm singlemode WDM
coupler and 1 x 2 splitter are not visible: both are mounted on the underside of the optical daughtercard
below the two dual LC bushings shown.
DUAL ST
BUSHING
TURRET
No customer switch settings are required for configuration of the FMB-X-2.5 remote card. All video
channels are handled at 10-bit digitization and all data slots are sampled as "high speed" slots, similar to
slot "D" on older 903 systems.
Focal Technologies Corp.
OPTICAL
DAUGHTERCARD
SFP CAGE
TRANSCEIVER

Figure 3.1-2: Remote FMB-X-2.5 Plan View

Model 903 User's Guide, FMB-X-2.5 Version
RX 1550 nm
SFP
TX 1310 nm
DIN 41612
96-PIN
BACKPLANE
CONNECTOR
Page 3-2