Sharp MD-X8 Operation Manual page 29

(Continued)
TRACK CD CD
MD
REC
Track editing
C D
3
W
W
C D
S T A R T
4
E N D
E D I T
C D
S T A R T
5
E N D
E D I T
C D
6
*27-37
REC
MD MD
MD
MULTI CONTROL
ENTER
CD
CD
4 5 : 0 9
D I S C 1
S T O P
M D T R A C K E D I T
T R A C K N o . 4
T R A C K N o . 4
T I M E
4 5 : 0 9 T O T A L
M D T R A C K E D I T
T R A C K N o . 4
T R A C K N o . 7
T I M E
7 2 1 : 4 8 T O T A L
4 0 : 0 2
MD
28
H H H H H Recording desired tracks from a CD
onto a MiniDisc (Track Editing)
You can record one track or a series of several tracks from
a CD onto an MD.You can select one track and record it. (If
the track numbers are not in succession, you cannot select
a series of tracks.)
1
Press the CD H button, and load compact discs.
2
Load a recordable MiniDisc.
3
Press the or on the MULTI CONTROL button to select
the track number you want to start recording from.
I The selected track number appears.
4
Press the TRACK button.
I To record a single track, skip to step 6.
5
Select the last track to be recorded recording by pressing the
TRACK button.
6
Press the CD 0 MD button.
I When all tracks are recorded, recording automatically stops.
If recording does not begin:
If an MD does not have enough space to record all of the tracks
from a CD, "EDIT OVER" will appear and the unit will enter the
recording stand-by mode.
pressed, a recording will be made. However, some tracks may
not be recorded.
To cancel operation:
Before pressing the CD 0 MD button, press the CD H or MD H
button.
To stop recording:
Press the CD H button.
After recording the track number, playback and recording will
stop. It is not possible to pause recording.
To rerecord:
If you wish to rerecord, you can erase a track that is already
recorded, starting from any point in the old track, to begin a new
recording.
Be aware that when you do this, all of the tracks and track names
that had been previously recorded after the newly recorded track
will be erased.
1
During playback, press the MD 06 button at the point where
you wish to begin rerecording.
I The unit will pause.
2
Press the REC I button.
I "RECORD & ERASE OK? "will appear.
3
Press the ENTER button.
I The unit will enter the record stand-by mode.
4
Select the recording source and start recording.
28
98.6.23, 10:32 AM
When the CD 0 MD button is