Table of Contents
Advertisement
USING THE ULTRASONIC PROCESSOR
Press the
|
key on the front panel. The screen will display the power rating and the
frequency of the Ultrasonic Processor, and the following control parameters.
AMPLITUDE: Amplitude is the intensity of sonication and the only parameter that must
be set in order for the Ultrasonic Processor to be operational.
parameters – Time and Pulse, do not have to be set for continuous operation. AMPL
Displays the percentage of amplitude that was previously selected. Press the
and then use the numeric keys to enter the desired value. Then depress the
ENTER/REVIEW
key. For example, to enter a value of 40% amplitude, first depress the
4
key, then the
0
key and then depress the
The screen will display:
The Ultrasonic Processor is now ready for continuous operation.
equipment, press the
press the
STOP
key or release the footswitch. If the Time or Pulse* functions must be
used, refer to the appropriate paragraphs(s) below.
To increase or decrease the amplitude in small increments when the equipment is on,
depress the
AMPL
selected, then depress the
CAUTION
Do not operate the power supply unless it is
connected to the converter.
TIME __:__:__
PULSE _ _ _ _
TIME __:__:__
PULSE _ _ _ _
START
key or the footswitch. To de-energize the equipment,
key to display the percentage of amplitude that was previously
▲
or
▼
key, as required.
NOTE
Any combination of functions can be
selected in any order. To clear an
erroneous entry press the CLEAR key.
TEMP__ __°C
AMPL__ __%
ENTER/REVIEW
key.
TEMP__ __°C
AMPL 40%
26
The other control
AMPL
key
To energize the
Advertisement
Table of Contents
