Setting The Video System; Capturing Projected Images - Sharp XG-PH70X-N Operation Manual

Using the "Options (1)" Menu

Setting the Video System

The video input system mode is factory preset
to "Auto"; however, a clear picture from the con-
nected audio-visual equipment may not be re-
ceived, depending on the video signal difference.
In that case, switch the video signal.
Menu operation Page
Example: "Options (1)" screen menu for
INPUT 4 (video) mode
Description of Video Systems
Selectable items
PAL (50/60 Hz) When connected to PAL video equipment.
SECAM When connected to SECAM video equipment.
NTSC4.43 When reproducing NTSC signals in PAL
video equipment.
NTSC3.58 When connected to NTSC video equipment.
Note
• The video signal can only be set in INPUT 4 or
INPUT 5 mode.
• When "Video System" is set to "Auto", you may
not receive a clear picture due to signal differ-
ences. Should this occur, switch to the video
system of the source signal.
• While "Video System" is set to "Auto", when
PAL-M or PAL-N signal is input, the image from
PAL signal will be displayed.
-76
58
Description

Capturing Projected Images

This projector allows you to capture projected
images (RGB signals) and set them as a startup
image, or background image when no signals are
being received.
Menu operation Page
Example: "Options (1)" screen menu for
INPUT 1 (RGB) mode
Note
• Images can be captured only when they are
from XGA (1024 × 768) non-interlace signals in
INPUT 1, INPUT 2 or INPUT 3 mode with
"RESIZE" set to "Normal".
• The saved image is reduced to 256 colors.
• Images from equipment connected to INPUT 4
or INPUT 5 terminal cannot be captured.
• Only one image can be captured and saved.
• The color of images may differ before and after
saving if an image is captured on which image
adjustment has been performed using the
"C.M.S." function.
• To delete the captured image, select "Delete",
and then press .
58