Setting On-Screen Display; Setting The Video System - Sharp NoteVision PG-MB60X Operation Manual

Using the "Options1" Menu

Setting On-screen Display

This function allows you to turn the on-screen
messages on or off.
Menu operation
Example: "Options1" screen menu for
INPUT 1 (RGB) mode
Description of OSD Display Settings
Selectable items
All On-screen Displays are displayed.
(ON)
• INPUT/VOLUME/AV MUTE/FREEZE/
AUTO SYNC/ENLARGE/ "An invalid
button has been pressed." are not
displayed.
(OFF)
• "All buttons on Projector are locked." is
displayed when the STANDBY button is
pressed while the Keylock function is
active.
-50
Downloaded From projector-manual.com Sharp Manuals
Page 42
Description

Setting the Video System

The video input system mode is factory preset
to "Auto"; however, a clear picture from the con-
nected audio-visual equipment may not be re-
ceived, depending on the video signal difference.
In that case, switch the video signal.
Menu operation Page
Example: "Options1" screen menu for
INPUT 3 (Video) mode
Description of Video Systems
Selectable items
PAL When connected to PAL video equipment.
SECAM When connected to SECAM video equipment.
NTSC4.43
When reproducing NTSC signals in PAL
video equipment.
NTSC3.58 When connected to NTSC video equipment.
Note
• The video signal can only be set in INPUT 3 or
INPUT 4 mode.
• When "Video System" is set to "Auto", you may
not receive a clear picture due to signal differ-
ences. Should this occur, switch to video sys-
tem of the source signal.
42
Description