Sharp Projector Remote Control Setup Manual page 17

The following additional steps are necessary only if AUDIO OUTPUT is
required. Please note that the speaker wire kept in the cart's black basket
needs to connected to either the CPU1 or CPU2 wall plate from the
workstation's speaker port )) (green-colored port on PC).
Please Note: The volume knob on the PRIMARY CONTROL is for the
ceiling speakers. The volume knob on the RECEIVER is for the speakers
on either side of the whiteboard.
5.0 On SWITCHER
5.1 Under the I/O label: Deselect the RGBS button (light should go off).
5.2 Under the I/O label: Select the Audio button (light should come on).
5.3 Select the CPU1 or CPU2 button, depending on which wall jack the
computer cable is connected to (CPU1 or CPU2) (red light should
come on).
5.4 Select button above label for PROJ1 CPU Audio output (lower left-
hand corner of switcher).
5.5 Press ENTER [right side of switcher].
6.0 Clean up
6.1 Power OFF to Projectors.
6.2 Power OFF to PRIMARY CONTROL.
6.3 Power Off to Workstation.
6.4 Disconnect all cables, but DO NOT disconnect the extension cables
from either the cpu or the monitor cable.
17