Sharp Projector Remote Control Setup Manual page 16

**Both projectors can be chosen if both screens are being used for display.
3.7 Press "ENTER" button [on the right side of switcher under "Control"
label].
4.0 Projector Remote Control (Should be on classroom podium)
Note: remote control does not work well with fluorescent lights on.
4.1 Take the remote control, point it towards the projector you are using,
and press the blue button on the upper left-hand corner. This is the
power button. It will take up to a minute for the projector to warm up.
There will be both solid and flashing green lights on the projector.
4.2 Once there are 2 solid green lights on the projector indicating that it
has warmed up, you should see the computer's image on the screen -
if the projector is not warmed up there will be no image on the screen.
If the projector is warmed up but there is still no image, press the
button labeled COMPUTER. Try pressing COMPUTER once again if
there is still no image on the screen.
4.3 If you no longer need the projector, or if it will be turned off for more
than 10 minutes, press the blue power button on the remote. This will
turn off the projector. Please note that you cannot immediately turn the
projector back on. It takes a few minutes for it to cool down and can
be turned back on when you see a solid red light on the projector.
*** To temporarily turn projector off, press MUTE on the remote.
Projector will turn itself back automatically in 10 minutes, or when
you press MUTE again.
16