Safety Precautions - Bosch AMC2 Series Installation Manual

AMC2 Modular
Controller
1.3

Safety Precautions

Read instructions!
Before working with the AMC2 device, read these instructions
carefully. Make sure you have understood all information
described in this document.
Warning!
Risk of electric shock
External power supplies must be installed and put into service
by qualified personnel.
!
Ensure compliance with the relevant regulations.
Ground the controller.
Disconnect both AC and battery power supply before working
on the controller.
Warning!
Risk of fire
Installation of the AMC2 device must comply with any local fire,
health, and safety regulations. A secured door that may be part
of an escape route from an area must be installed with:
!
Install a fail-safe lock (A), so that the door will be released if
power fails. Ideally, use a magnetic lock.
Install a normally-closed break glass or a manual pull (B) in the
lock supply wiring, so that in an emergency the fail-safe lock
can be immediately powered down.
Warning!
Risk of explosion of Lithium battery
The battery can explode if it is replaced incorrectly.
!
Replace only with the same type as recommended by the
manufacturer.
Dispose used batteries according to the battery manufacturer's
instructions.
Bosch Access Systems GmbH
Safety Instructions | en
2018-09 | AMC2-4W_UL |
9