Care & Maintenance - Kogan KA9FUNOVENA Instruction And Installation Manual

Cleaning & Maintenance
By ensuring proper cleaning and maintenance of your
oven, you can ensure that it will have a long and fault
free operation.
WARNING.
Do not start cleaning the oven until it has completely
cooled.
• Typically you should only ever need to clean your
oven with warm soapy water, or light cleaning
products to assist with the removal of fat or oil
emulsions.
• Your oven should be cleaned after every use and you
can use the "Light" function to assist with visibility.
• After cleaning your oven chamber, you should wipe
it dry.
CLEANING THE GLASS
• Glass surfaces on the door and control panel should
be cleaned immediately after soiling, using a damp
cloth.
• Oven cleaners may be used to remove stubborn stains
and built-up residues.
• Avoid the use of harsh abrasive cleaners and sharp
metal scrapers as they can scratch or damage the
surface.
CLEANING THE STAINLESS STEEL
All grades of stainless steel can stain or discolour and
you must regularly ensure it's kept clean using the
following procedures:
• Start by using clean, warm soapy water. For stubborn
stains or discolouration, you can try stainless steel
cleaners available from the supermarket.
• Be careful when cleaning the stainless steel, as there
may be sharp edges.
• DO NOT use abrasive or harsh solvent cleaners.
CLEANING THE OVEN/GRILL
• Always keep the internal of the oven clean, ensuring
that fats and oils don't accumulate around the
elements or fan.
• Always keep the oven dish, baking trays and grill dish
inserts clean as any deposits may catch fire or smoke.
• Always wrap your meats in aluminium foil or use
a covered oven-roasting dish to minimise required
cleaning.
DOOR REMOVAL
In order t o obtain easier access to the oven chamber
for cleaning, it is possible to remove the door.
To do this:
• Tilt the safety catch part of the hinge upwards.
• Close the door lightly, lift and pull it out towards you.
• In order to fit the door back on to the oven, do the
reverse.
When fitting, ensure that the notch of the hinge is
correctly placed on the protrusion of the hinge holder.
After the door is fitted to the oven, the safety catch
should be carefully lowered down again. If the safety
catch is not set it may cause damage to the hinge when
closing the door.
REPLACEMENT OF THE OVEN LIGHT GLOBE
WARNING.
In order to avoid the possibility of an electric shock,
ensure that the appliance is switched off at the isolator
switch, before removing the light globe.
• Set all control knobs to the off position and switch the
oven off at the isolator switch.
• Unscrew the Light Globe cover. Unscrew the blown
light globe.
• Replace the globe with a new oven globe with the
following parameters:
– Voltage: 230v
– Power: 25W
– E14 Oven globe
• Screw the Light Globe cover back into place.
10